Step 1 - Site properly prepared
4" - 6" clean stone
9 linear blocks 1" x 8" x 16"
You will receive complete instructions brochure that has all the information needed with your gazebo.
Tools Required
- Electric Drill
- Tape Measure
- Clamp (for connecting roof rafters)
- 6' & 8' Step Ladders
- Adjustable and Box or Socket Wrench
- Hammer
Step 2 - Materials banded and wrapped on skid.
Step 3 - Disassemble the skid,
moving screens and door aside.
Step 4 - Each flor section is screwed to another to stabilize the package. Remove those screws.
Step 5 - With floor panels and all other components safely place where convenient, remove vertical straps holding flor sections in place.
Step 6 - Remove lag bolts holding flor sections to skid.
Step 7 - Positon one section of the floor with inside corner on center of octagon and edge on centr of outside block.
Step 8 - Vinyl gazebo floor sections are preassembeled and numbered at the factory. While placement is not important in relationship to the door it is important that adjacent numbers match.
Step 9 - Remove loose boards #2 and #8.