Step 10 - Place posts making sure that roof brackets are facing outboard (see #15) and post is fully seated on floor joist.

Step 11 - Insert bolts through post/joist bracket and tighten fully, making sure that outside corners of floor sections are properly aligned (See #12).

Step 12

Step 13 - With post bolts fully tightened insert bolts through pre-drilled holes in joist at floorboard #8 position and tighten fully, making sure that floor boards are flat with each other.

Step 14 - Complete floor by adding center boards and securing with screws.

Step 15 - Deck and posts completed.

Step 16 - For gazebo kits without screen package, position header in doorway with top aligned with top of roof bracket and vertical plate centered on post, fasten with screws.

Step 17 - Pause and admire
Step 18 - Position and secure top railing sections in each opening aligning as previous step.

Step 19 - Install lower railing section with vertical plate resting on deck and centered on post. Note that there are 4 screws in each plate.

Step 20 - With bottom and top railing in place and secure, position door assembly in opening.